https://www.dropbox.com/s/nqlyvc2lurpxn1k/38350016_Colt_Ralliart_Version-R_JDM_2007.zip?dl=0

The 400 load blog posts on this site apply to the above XML too.  If you’re after a base file to start from, heres one with the 400 load patch applied, and the MUT table adjsuted to enable the required 2 byte load logging:

https://www.dropbox.com/s/qfaombe6vn1gkik/Stock%20Map-2%20Pot%20400L.bin?dl=0

Note this is for the Manual JDM Rcolts only – do not flash this onto a CVT one (unless you’ve converted it to manual), or an AUDM Rcolt.

If you’re after the 400 load patch and XML for Australian Mitsubishi Colt Ralliarts, I’ve ported Antti’s work to AUDM, and added it into my extended XML for Aussie Rcolts. I’ll do a post/share that when I get time.

Apologies for the brievity, hope this helps & good luck!

The post JDM Z27AG Mitsubishi Colt Ralliart Version R 400 Load Patch XML appeared first on Turbo Colt.

I’ve made an XML stub file to help in the process, but it’s not essential.   If you’re looking for the complete XML for the JDM models I might be able to help (leave a comment below and I’ll email you).

Anyway back to downloading your ECU rom image.  Here goes:

Install EcuFlash from this link

https://www.dropbox.com/s/u55hat1zck70krz/ecuflash_1444247_win_beta.exe?dl=0

I’ve had reports that the later versions of ECUFlash have some issues reading and writing, so until I’ve investigated these myself I recommend running this older version.

Put the XML in

Go to C:\Program Files (x86)\OpenECU\EcuFlash\rommetadata\mitsubishi folder

Make directory called ‘Ralliart Colt Turbo’

Download these two xml files and put it in this new folder

https://www.dropbox.com/s/7k5nw3ywjnnfwsf/38350016%20JDM%20MT%20Andy.xml?dl=0
https://www.dropbox.com/s/nudulw5nrts9jes/Coltbase.xml?dl=0

Connect to your ECU

Connect the tactrix to your computer via USB.

Run EcuFlash

In the Menu to ECU->Select Vehicle Type. Make sure its set to Colt (768k) 2006+ mitsubootloader M32176F6. There should only be one Colt (768k) entry.

Now you should be ready to read your ROM!

**

In the car, boot up your laptop. Connect Tactrix to laptop. Now connect to OBDII port of your car.

Now with everything connected up you should be able to go menu ECU-> Read from ECU

Software will display an information box asking you to turn on your ignition. Do so, and then click ok. You want ignition on, not just accessories.

It should now be reading your rom. If not? Remove tactrix from OBDII port and reconnect it. Try again. If still not working, unplug it from the computer and the car, then plug back into the computer, then the car, and try again. Still not working? Try wobbling it in the OBDII port to put it at a small angle (just to see if that improves the contacts). Still not working? Houston we have a problem.

Assuming no problem, and the ROM was downloaded?!

Go Menu File – Save ROM As, change the file type to .BIN, call it something, and done.

EPIC WINS.  You have now completed your Z27AG JDM Colt Version R ECU Download.

The post Z27AG JDM Colt Version R ECU Download appeared first on Turbo Colt.